![\"\"](\"https:\/\/www.craftypaws.us\/wp-content\/uploads\/2018\/12\/20181221_201142-1024x576.jpg\")
<\/figure>\r\n\r\n\r\n\r\nTo create this wreath, I used a pot lid to trace a large circle on some foam core board<\/a> and then used an X-Acto blade<\/a> to cut it out. Then I found the center of the circle and used a ruler with a hole at one end to trace a smaller circle, using the ruler as a kind of jerry-rigged compass. I cut out this smaller concentric circle to create the wreath base.<\/p>\r\n\r\n\r\n\r\n Then it was a matter of deciding where to position each Copic colored and framed puppy. When I had done a LOT of futzing, I glued all the puppies into place, the larger ones at the 12, 3, 6 and 9 o’clock positions and the smaller ones at the 1, 2, 4, 5, 7, 8, 10 and 11 o’clock positions. Spacing was a little tricky, but using my favorite Art Glitter Glue<\/a> and Fine Tip Nozzle<\/a> really helped with a little bit of wriggle room in the drying time.<\/p>\r\n\r\n\r\n\r\n Lastly, I decided to add some extra embellishments with all the die cut red circles and rings that I had left over after cutting out all those frames for the puppy images. I had just enough to completely add an extra layer around the wreath of circles and circles with rings around the base wreath. To add a little sparkle, I used the 3rd largest circle from the Diemond Dies Die-Normous Stack-Ems Circle Nesting Die Set<\/a> on some silver glitter card stock to add a sparkly center to all the red circles.<\/p>\r\n\r\n\r\n\r\n CLICK on the picture below link to watch the whole wreath making process tutorial:<\/p>\r\n![\"\"](\"https:\/\/www.craftypaws.us\/wp-content\/uploads\/2018\/12\/20181221_201104-1024x576.jpg\")
<\/figure>\r\n\r\n\r\n\r\n![\"\"](\"https:\/\/www.craftypaws.us\/wp-content\/uploads\/2018\/12\/20181221_201115-1024x576.jpg\")
<\/figure>\r\n\r\n\r\n\r\n